![]() The initialization code in sparkfun starts the SPI Library and sets the mode to 3, it also configure the CS pin to OUTPUT as it supposed to be, the it puts the CS to HIGH. Serial.println("SparkFun ADX元45 Accelerometer Hook Up Guide Example") Īdxl.setSpiBit(0) // Configure the device to be in 4 wire SPI mode when set to '0' or 3 wire SPI mode when set to 1Īdxl.readAccel(&x, &y, &z) // Read the accelerometer values and store them in variables declared above x,y,z While ( !Serial ) delay(10) // for nrf52840 with native usb Since Arduino cores have been developed for a variety of architectures, this library will not 'just work' for any Arduino-compatible board. Serial.begin(115200) // Start the serial terminal This library looked very promising, but note it does only support AVR targets. #include // SparkFun ADX元45 LibraryĪDX元45 adxl = ADX元45(11) // USE FOR SPI COMMUNICATION, ADX元45(CS_PIN) ![]() The same code I’m posting works perfectly on my Arduino Uno, but if I try to run it on the feather it get stuck on powerOn method. Regarding capability, it has a key difference, a built-in USB interface. We’ll show you how to wire the sensor to the ESP8266, install the required libraries, and write. The BME280 sensor uses I2C or SPI communication protocol to exchange data with a microcontroller. ![]() It is similar to the 328p regarding specifications. This guide shows how to use the BME280 sensor module with the ESP8266 to read pressure, temperature, humidity and estimate altitude using Arduino IDE. I'm using the ADX元45 SparkFun library read values from it. The 32u4 is the same processor found in the Arduino Leonardo. Adafruit Zero FFT Library FFT library for Arduino Zero / Adafruit Feather M0. I’m experiencing some issue in trying to make ADX元45 accelerometer works in SPI by using an nRF52 feather. 4bo otloaderszero (or where-ever the current version of your Arduino SAMD.
0 Comments
Leave a Reply. |